motorcycle repair
motorcycle repair and troubleshooting

Home Repair Tips
- Vehicle Repair -
Motorcycle Repair Directory
Motorcycle Repair & Troubleshooting
Motorcycle Repair
- 2007 - 2008 -
Yamaha Motorcycles
Suzuki Motorcyles
BMW Motorcycles
Ducati Motorcycles
Triumph Motorcycles
Custom Search
Search Motorcyle Repair
How to Remove a Gl1500 Goldwing Front Wheel GL1500 front wheel removal, covers GL1500 models from 1988-2000.


  1. First thing is to get a jack ready for the Goldwing, make sure it's a sturdy jack. The bottom of the GL1500 engine is flat and ideal for jacking up. A flat block of wood between the jack and engine will prevent the GL1500 sump being damaged by the jack and will also be less likely to slip. Don't jack the Goldwing up just yet.
  2. Pull the upper side mudguard/fender trim off as in the first picture below (right side shown). Then remove the lower 8mm bolts from the rotor covers. Don't lose the spacers visible in the third picture.
  3. Remove the 8mm bolt from the top of the rotor cover and bracket and remove the rotor cover as shown below. Note how the two-part bracket slots together in the first picture. These brackets sit over the top of the rotor trim, not under it.
  4. Remove the two Allen bolts holding the brake callipers in place and slide the callipers off the brake disc as shown in the next three pictures.
  5. Now remove the 22mm bolt from the right-side of the axle, as in the first picture. Then slacken off the fork to axle pinch bolts as shown in the following two. There is no need to remove these bolts. In the third picture, I've highlighted the small stop on the fork leg. When refitting the speedo drive, make sure that the stop on the drive is behind the one on the fork leg, otherwise when you ride the Goldwing the drive will turn forward and break the speedo cable. Now it's time to jack the Goldwing up so that the wheel is about an inch off the ground.
  6. With the Goldwing jacked up, push the axle out with a drift from the right side, then pull it fully out to the left as shown in the two pictures below.
  7. Pull the speedo drive away as you roll the wheel out as in the picture. You don't need to remove the speedo cable from the drive first, you can remove them together. You may need to jack the Goldwing up a bit more so the wheel clears the mudguard/fender.
  8. On the right side, note the spacer that sits in the middle of the wheel shown in the picture. The flared end faces against the fork leg and the other end sits into the bearing dust seal in the wheel.
  9. When refitting the wheel, note the points I made about the spacer and the speedo drive. The last thing you will be doing is putting the mudguard/fender back in place. Make sure that you push the rear end in so it's flush with the rear of the fender, as shown in this picture. Many people don't push the trims in fully and of course they fall off when you take the Goldwing for a ride.


Related wikiHows

Sources and Citations

Article provided by wikiHow, a wiki how-to manual. Please edit this article and find author credits at the original wikiHow article on How to Remove a Gl1500 Goldwing Front Wheel. All content on wikiHow can be shared under a Creative Commons license.

Custom Search
Search Motorcyle Repair
Honda Gl1500 Goldwing Front Wheel